Figuring Out Equipment

Cost of Waterjet Cutting

You will realize that so many people have fallen for waterjet cutting. It is hardly uncommon for one to seek to understand the cost of waterjet cutting. It is necessary to understand that there are various costs incurred in running waterjet cutting processes. You will learn that there are a number of consumables as well as power requirements that will need to be addressed. You will learn that water and abrasive will feature certain costs too. There are basically six different configurations known. They attract different costs. It is therefore necessary to understand all the costs attached to this waterjet cutting. They will every so often include the following.

Water does attract some costs. You will actually find that this is what will cost you the least among all. This water is relied on for cutting as well as cooling. In most cases, 3.5 dollars will be spent on a 1000 gallon. This will go ahead to cost you a figure of between 1200 and 2500 dollars each year. It is imperative to mention that there will be a need for you to pay an extra amount for the sewer as well. This will often depend on your location. There are particular regions that will attract a bigger amount than the others. It is necessary to understand that the intensifier pump will also have to be operated. This will often mean that there is a need for power. Igt is certain that you will have to spend an amount that ranges between 3700 and 9400 on a yearly basis for power. This will however be guided by your usage. These figures are given for pumps of between 50 and 125HP.

Abrasive does attract a cost too. It will definitely cost more than all the others. You will learn that there are basically two types of garnet available. There is usually the hard rock garnet and the alluvial one. You will realize that hard rock is appreciated as being sharper. This is what will make it tend to cut faster. You will note that the alluvial garnet will be characterized by rounded grains. This is what will raise the cost of the hard rock. It is also important for you to pay attention to the expenses attracted by the abrasive flow rate. It will every so often call for you to spend about 26000 to 55000 dollars each year.

It will also be necessary for you to take into account the cost of wear and tear. Replacement of certain parts such as orifice will be quite common. We have miscellaneous pump part costs too. You can spend on them up to 32000 dollars each year.

3 Resources Tips from Someone With Experience

3 Resources Tips from Someone With Experience

Post Author: admin