Procedures to Use in Building Split Rail Fencing
A split rail fence is one the oldest fencing methods utilized by people to fence their farmhouses. Those people who reside near the forests should know the importance of knowing the procedure for split rail fence installation. This is for the reason that the enclosure is mostly found in forested areas because it makes most of the materials in wooden area.
It is both beautiful and appealing despite the fact that this method is old-fashioned and many people still use this especially those who still keep in touch with tradition. It is easy, generally well-fortified and economical. The installation is functional and the tools required are basic such as wedge, a pair of gloves, helmet, and axe. The most important of all is that it is essential in recycling unusable timbers and producing a useful and appealing enclosure.
The first step you need to do is to ascertain in which area you would install the fence. You need to see first if the area you chose is safe for one to dug. Also, see to it that there is no gas, water or power line beneath the area you are supposed to dig up holes. The lines can be risky to the workforce and to those around the area.
After choosing the perfect area to install your fence, measure the perimeter of the area you want to enclose. Moreover, the boundary line should be marked in order to avoid confusion. In order to do this, put a mark around the corners using ground stakes and make an outline by tying a guide from one corner to another. Through this, you can be able to make a straight and well-stretch line.
With your guideline still in position, set up your corner posts. Dig a hole in order to set the split posts depth. To be exact, it should accommodate a third of the total length of the post. After that put the concrete to an approximately 24 inches deep, then let it rest for at least 72 hours. Place your posts at an approximate distance of 10 to 12 feet from each other. Once it is all done, remove the guidelines and see to it if the posts are align to each other.
Also, set up a guide wire and check if the posts are vertically upright. The purpose putting a wire is to find out the precision of the line.
Measure the length of the posts and make sure that the sizes are similar as possible to maintain a spruce look. Using a wedge or axe, cut the post from the top to bottom.
The last step is to join the split post and rail together by using hammer and drive nails. The place will not only keep the place beautiful within, but it will also serve as a strong protection from any destruction.